Following the pre-release of my printer design, BotMaker, here is a more complete follow up, and the first section is focused on the assembly of the printer.


Here is how it looks!

The following images consist on the assembly guides version 1.0.

****Edit**** I´ve just realize that we only use one extrusions in the bottom midle, and not two like the previous render showed. There is only space for one!

Note that there are 3 holes on the top cover - that's where I attached my electronics. In this case a ramps 1.4 board.

BotMaker - BOM

M2 x 15mm - 6 (for the endstops)

M3 x 10mm - 33

M3 x 16mm - 20

M3 x 20mm - 9

M3 x 35mm - 2

M3 nuts - 26

M3 washers - aprox  10

M4x10mm - 27

T-nuts - 27

M5 nut - 2

M5 threaded rod x 240mm - 2

M8 smooth rods:

                260mm -2

                200mm -2

                215mm -2

LM8UU - 10

F623 bearings - 17

GT2 belt aprox. 940mm

GT2 pulley -2

Nema 17 - 5

Endstop - 3 (OMRON D2F)

Springs -4

MK7 drive gear - 1

Bowden tube - aprox. 400mm

Hotend - 1

Fan  - 1

Pneumatic push-fit  4mm - 2

Extrusions:

                310mm - 4

                220mm - 2

                180mm - 5

Extrusion brackets - 16 (each one needs two M4x8mm and two t-nuts )

Printed Parts:

Hotend holder - 1

Hotend fan holder  - 2

X end right -1

X end left - 1

X carriage - 1

Y idler - 1

Y idler+endstop -1

Y motor -1

Y carriage - 1

Extruder body -1

Z motor holder left -1

Z motor holder right - 1

Z top holder left -1

Z top holder right -1

Z couplings - 4

Laser cut parts - 5mm material.

X motor support - 1

Print bed - 1

Y bed - 1

Case: front, left, right, back and top - one of each.

I think that's all for now. 

Cheers